Commit fde84f19 authored by Claudiu Beznea's avatar Claudiu Beznea Committed by Linus Walleij
Browse files

dt-bindings: add bindings for SAM9X60 



Add device tree binding for SAM9X60 pin controller.

Signed-off-by: default avatarClaudiu Beznea <claudiu.beznea@microchip.com>
Acked-by: default avatarLudovic Desroches <ludovic.desroches@microchip.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
parent 1d741f2e

Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt

+3 −2
Original line number Diff line number Diff line
@@ -19,7 +19,7 @@ such as pull-up, multi drive, etc. 


Required properties for iomux controller:

- compatible: "atmel,at91rm9200-pinctrl" or "atmel,at91sam9x5-pinctrl"

		or "atmel,sama5d3-pinctrl"

		or "atmel,sama5d3-pinctrl" or "microchip,sam9x60-pinctrl"

- atmel,mux-mask: array of mask (periph per bank) to describe if a pin can be

  configured in this periph mode. All the periph and bank need to be describe.
@@ -117,7 +117,8 @@ Some requirements for using atmel,at91rm9200-pinctrl binding: 
4. The gpio controller must be describe in the pinctrl simple-bus.



For each bank the required properties are:

- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio"

- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" or

  "microchip,sam9x60-gpio"

- reg: physical base address and length of the controller's registers

- interrupts: interrupt outputs from the controller

- interrupt-controller: marks the device node as an interrupt controller

CRA Git | Maintained and supported by SUSTech CRA and CCSE