+17
−0
+1
−0
Loading
Gitlab 现已全面支持 git over ssh 与 git over https。通过 HTTPS 访问请配置带有 read_repository / write_repository 权限的 Personal access token。通过 SSH 端口访问请使用 22 端口或 13389 端口。如果使用CAS注册了账户但不知道密码,可以自行至设置中更改;如有其他问题,请发邮件至 service@cra.moe 寻求协助。
Jeremy Linton says:
====================
Add ACPI bindings to the genet
This patch series allows the BCM GENET, as used on the RPi4,
to attach when booted in an ACPI environment. The DSDT entry to
trigger this is seen below. Of note, the first patch adds a
small extension to the mdio layer which allows drivers to find
the mii_bus without firmware assistance. The fifth patch in
the set retrieves the MAC address from the umac registers
rather than carrying it directly in the DSDT. This of course
requires the firmware to pre-program it, so we continue to fall
back on a random one if it appears to be garbage.
v1 -> v2:
fail on missing phy-mode property
replace phy-mode internal property read string with
device_get_phy_mode() equivalent
rework mac address detection logic so that it merges
the acpi/DT case into device_get_mac_address()
allowing _DSD mac address properties.
some commit messages justifying why phy_find_first()
isn't the worst choice for this driver.
+ Device (ETH0)
+ {
+ Name (_HID, "BCM6E4E")
+ Name (_UID, 0)
+ Name (_CCA, 0x0)
+ Method (_STA)
+ {
+ Return (0xf)
+ }
+ Method (_CRS, 0x0, Serialized)
+ {
+ Name (RBUF, ResourceTemplate ()
+ {
+ Memory32Fixed (ReadWrite, 0xFd580000, 0x10000, )
+ Interrupt (ResourceConsumer, Level, ActiveHigh, Exclusive) { 0xBD }
+ Interrupt (ResourceConsumer, Level, ActiveHigh, Exclusive) { 0xBE }
+ })
+ Return (RBUF)
+ }
+ Name (_DSD, Package () {
+ ToUUID("daffd814-6eba-4d8c-8a91-bc9bbf4aa301"),
+ Package () {
+ Package () { "phy-mode", "rgmii-rxid" },
+ }
+ })
+ }
====================
Tested-by:
Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by:
David S. Miller <davem@davemloft.net>
CRA Git | Maintained and supported by SUSTech CRA and CCSE