Commit ca45448a authored Mar 10, 2020 by Lad Prabhakar Committed by Mauro Carvalho Chehab Mar 12, 2020

media: i2c: imx219: Fix power sequence

When supporting Rpi Camera v2 Module on the RZ/G2E, found the driver had
some issues with rcar mipi-csi driver. The sensor never entered into LP-11
state.

The powerup sequence in the datasheet[1] shows the sensor entering into
LP-11 in streaming mode, so to fix this issue transitions are performed
from "streaming -> standby" in the probe() after power up.

With this commit the sensor is able to enter LP-11 mode during power up,
as expected by some CSI-2 controllers.

[1] https://publiclab.org/system/images/photos/000/023/294/original/


RASPBERRY_PI_CAMERA_V2_DATASHEET_IMX219PQH5_7.0.0_Datasheet_XXX.PDF

Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com>
Acked-by: Dave Stevenson <dave.stevenson@raspberrypi.com>
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>

parent da849679

drivers/media/i2c/imx219.c

+17 −0

Original line number	Diff line number	Diff line
		@@ -1224,6 +1224,23 @@ static int imx219_probe(struct i2c_client *client)
		/* Set default mode to max resolution */
		imx219->mode = &supported_modes[0];

		/* sensor doesn't enter LP-11 state upon power up until and unless
		* streaming is started, so upon power up switch the modes to:
		* streaming -> standby
		*/
		ret = imx219_write_reg(imx219, IMX219_REG_MODE_SELECT,
		IMX219_REG_VALUE_08BIT, IMX219_MODE_STREAMING);
		if (ret < 0)
		goto error_power_off;
		usleep_range(100, 110);

		/* put sensor back to standby mode */
		ret = imx219_write_reg(imx219, IMX219_REG_MODE_SELECT,
		IMX219_REG_VALUE_08BIT, IMX219_MODE_STANDBY);
		if (ret < 0)
		goto error_power_off;
		usleep_range(100, 110);

		ret = imx219_init_controls(imx219);
		if (ret)
		goto error_power_off;

Admin message