+12
−0
+619
−0
Loading
Gitlab 现已全面支持 git over ssh 与 git over https。通过 HTTPS 访问请配置带有 read_repository / write_repository 权限的 Personal access token。通过 SSH 端口访问请使用 22 端口或 13389 端口。如果使用CAS注册了账户但不知道密码,可以自行至设置中更改;如有其他问题,请发邮件至 service@cra.moe 寻求协助。
For Lynxpoint and Wildcat Point solution, is it host's responsibility to allocate SRAM regions and ensure those already taken are not overwritten with other data until released. Blocks are transferred to SRAM - either IRAM or DRAM - via DW DMA controller. Once basefw is booted, ownership of DMA transfer is lost in favour of DSP. Hosts reponsibilities don't end on initial block allocation and binary transfer. During Dx transitions host must store FW runtime context from DRAM before putting AudioDSP subsystem into lower power state. Said context gets flashed after D0 entry to bring DSP right where it was just before suspending. Load and restore procedures are finalized with SRAM power gating and adequate clock level selection. This power gates unused EBBs and clock speed effectively reducing power consumption. Signed-off-by:Cezary Rojewski <cezary.rojewski@intel.com> Reviewed-by:
Andy Shevchenko <andriy.shevchenko@intel.com> Reviewed-by:
Andy Shevchenko <andriy.shevchenko@linux.intel.com> Link: https://lore.kernel.org/r/20200929141247.8058-6-cezary.rojewski@intel.com Signed-off-by:
Mark Brown <broonie@kernel.org>
CRA Git | Maintained and supported by SUSTech CRA and CCSE