Commit a6e45620 authored Jun 17, 2019 by Lee Jones Committed by Felipe Balbi Jun 18, 2019

usb: dwc3: qcom: Start USB in 'host mode' on the SDM845



When booting with Device Tree, the current default boot configuration
table option, the request to boot via 'host mode' comes from the
'dr_mode' property.  A property of the same name can be used inside
ACPI tables too.  However it is missing from the SDM845's ACPI tables
so we have to supply this information using Platform Device Properties
instead.

This does not change the behaviour of any currently supported devices.
The property is only set on ACPI enabled platforms, thus for H/W
booting DT, unless a 'dr_mode' property is present, the default is
still OTG (On-The-Go) as per [0].  Any new ACPI devices added will
also be able to over-ride this implementation by providing a 'dr_mode'
property in their ACPI tables.  In cases where 'dr_mode' is omitted
from the tables AND 'host mode' should not be the default (very
unlikely), then we will have to add some way of choosing between them
at run time - most likely by ACPI HID.

[0] Documentation/devicetree/bindings/usb/generic.txt

Signed-off-by: Lee Jones <lee.jones@linaro.org>
Reviewed-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>

parent 2bc02355

drivers/usb/dwc3/dwc3-qcom.c

+12 −0

Original line number	Diff line number	Diff line
		@@ -444,6 +444,11 @@ static int dwc3_qcom_clk_init(struct dwc3_qcom *qcom, int count)
		return 0;
		}

		static const struct property_entry dwc3_qcom_acpi_properties[] = {
		PROPERTY_ENTRY_STRING("dr_mode", "host"),
		{}
		};

		static int dwc3_qcom_acpi_register_core(struct platform_device *pdev)
		{
		struct dwc3_qcom *qcom = platform_get_drvdata(pdev);
		@@ -488,6 +493,13 @@ static int dwc3_qcom_acpi_register_core(struct platform_device *pdev)
		goto out;
		}

		ret = platform_device_add_properties(qcom->dwc3,
		dwc3_qcom_acpi_properties);
		if (ret < 0) {
		dev_err(&pdev->dev, "failed to add properties\n");
		goto out;
		}

		ret = platform_device_add(qcom->dwc3);
		if (ret)
		dev_err(&pdev->dev, "failed to add device\n");

Admin message