docs: misc-devices/apds990x.txt: convert to ReST format

.. SPDX-License-Identifier: GPL-2.0

======================

Kernel driver apds990x

======================

power_state

	RW - enable / disable chip. Uses counting logic

	     1 enables the chip

	     0 disables the chip

lux0_input

	RO - measured lux value

	     sysfs_notify called when threshold interrupt occurs

lux0_sensor_range

	RO - lux0_input max value. Actually never reaches since sensor tends

	RO - lux0_input max value.

	     Actually never reaches since sensor tends

	     to saturate much before that. Real max value varies depending

	     on the light spectrum etc.

	RO - supported measurement rates

lux0_calibscale

	RW - calibration value. Set to neutral value by default.

	RW - calibration value.

	     Set to neutral value by default.

	     Output results are multiplied with calibscale / calibscale_default

	     value.

	RO - neutral calibration value

lux0_thresh_above_value

	RW - HI level threshold value. All results above the value

	RW - HI level threshold value.

	     All results above the value

	     trigs an interrupt. 65535 (i.e. sensor_range) disables the above

	     interrupt.

lux0_thresh_below_value

	RW - LO level threshold value. All results below the value

	RW - LO level threshold value.

	     All results below the value

	     trigs an interrupt. 0 disables the below interrupt.

prox0_raw

	RO - measured proximity value

	     sysfs_notify called when threshold interrupt occurs

prox0_sensor_range

prox0_raw_en

	RW - enable / disable proximity - uses counting logic

	     1 enables the proximity

	     0 disables the proximity

	     - 1 enables the proximity

	     - 0 disables the proximity

prox0_reporting_mode

	RW - trigger / periodic. In "trigger" mode the driver tells two possible

	RW - trigger / periodic.

	     In "trigger" mode the driver tells two possible

	     values: 0 or prox0_sensor_range value. 0 means no proximity,

	     1023 means proximity. This causes minimal number of interrupts.

	     In "periodic" mode the driver reports all values above

   :maxdepth: 2

   ad525x_dpot

   apds990x

   bh1770glc

   eeprom

   c2port