+4
−0
+8
−6
Loading
ipv4: Allow amount of dirty memory from fib resizing to be controllable
fib_trie implementation calls synchronize_rcu when a certain amount of pages are dirty from freed entries. The number of pages was determined experimentally in 2009 (commit c3059477). At the current setting, synchronize_rcu is called often -- 51 times in a second in one test with an average of an 8 msec delay adding a fib entry. The total impact is a lot of slow down modifying the fib. This is seen in the output of 'time' - the difference between real time and sys+user. For example, using 720,022 single path routes and 'ip -batch'[1]: $ time ./ip -batch ipv4/routes-1-hops real 0m14.214s user 0m2.513s sys 0m6.783s So roughly 35% of the actual time to install the routes is from the ip command getting scheduled out, most notably due to synchronize_rcu (this is observed using 'perf sched timehist'). This patch makes the amount of dirty memory configurable between 64k where the synchronize_rcu is called often (small, low end systems that are memory sensitive) to 64M where synchronize_rcu is called rarely during a large FIB change (for high end systems with lots of memory). The default is 512kB which corresponds to the current setting of 128 pages with a 4kB page size. As an example, at 16MB the worst interval shows 4 calls to synchronize_rcu in a second blocking for up to 30 msec in a single instance, and a total of almost 100 msec across the 4 calls in the second. The trade off is allowing FIB entries to consume more memory in a given time window but but with much better fib insertion rates (~30% increase in prefixes/sec). With this patch and net.ipv4.fib_sync_mem set to 16MB, the same batch file runs in: $ time ./ip -batch ipv4/routes-1-hops real 0m9.692s user 0m2.491s sys 0m6.769s So the dead time is reduced to about 1/2 second or <5% of the real time. [1] 'ip' modified to not request ACK messages which improves route insertion times by about 20% Signed-off-by:David Ahern <dsahern@gmail.com> Signed-off-by: