Commit 97028ce6 authored by Mika Westerberg's avatar Mika Westerberg Committed by Rafael J. Wysocki
Browse files

ACPICA: ACPI 6.2: Add support for PinConfig() resource 

ACPICA commit a06fdba686cefccd5dd5b93b52fa0f1e3f984906

ACPI 6.2 introduced a new resource that is used to specify fine-grained
configuration of a pin or set of pins used by a device. The ASL syntax of
this new resource looks like:

  PinConfig (Shared/Exclusive, PinConfigType, PinConfigValue,
             ResourceSource, ResourceSourceIndex, ResourceUsage,
             DescriptorName, Vendordata) {Pin List}

PinConfigType is an integer with following accepted values:

  0x00 (Default) - No configuration is applied to the pin
  0x01 (Bias Pull-up) - Pin is pulled up using certain size resistor
  0x02 (Bias Pull-down) - Pin is pulled down using certain size resistor
  0x03 (Bias Default) - Set to default biasing
  0x04 (Bias Disable) - All bias settings will be disabled
  0x05 (Bias High Impedance) - Configure the pin as hi_z
  0x06 (Bias Bus Hold) - Configure the pin in a weak latch state where
                         it drives the last value on a tristate bus
  0x07 (Drive Open Drain) - Configure the pin into open drain state
  0x08 (Drive Open Source) - Configure the pin into open source state
  0x09 (Drive Push Pull) - Configure the pin into push-pull state
  0x0a (Drive Strength) - How much the pin can supply current
  0x0b (Slew Rate) - Configure slew rate of the pin
  0x0c (Input Debounce) - Enable input debouncer for the pin
  0x0d (Input Schmitt Trigger) - Enable schmitt trigger for the pin
  0x0e - 0x7f - Reserved
  0x80 - 0xff - Vendor defined types

The PinConfigValue depends on the type and is expressed as units
suitable for that type (for example bias uses Ohms).

Link: https://github.com/acpica/acpica/commit/a06fdba6


Signed-off-by: default avatarMika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: default avatarLv Zheng <lv.zheng@intel.com>
Signed-off-by: default avatarBob Moore <robert.moore@intel.com>
Signed-off-by: default avatarRafael J. Wysocki <rafael.j.wysocki@intel.com>
parent 2b726930

drivers/acpi/acpica/aclocal.h

+2 −1
Original line number Diff line number Diff line
@@ -1144,7 +1144,8 @@ struct acpi_port_info { 
#define ACPI_RESOURCE_NAME_GPIO                 0x8C

#define ACPI_RESOURCE_NAME_PIN_FUNCTION         0x8D

#define ACPI_RESOURCE_NAME_SERIAL_BUS           0x8E

#define ACPI_RESOURCE_NAME_LARGE_MAX            0x8E

#define ACPI_RESOURCE_NAME_PIN_CONFIG           0x8F

#define ACPI_RESOURCE_NAME_LARGE_MAX            0x8F



/*****************************************************************************

 *

drivers/acpi/acpica/acresrc.h

+2 −0
Original line number Diff line number Diff line
@@ -330,6 +330,7 @@ extern struct acpi_rsconvert_info acpi_rs_convert_i2c_serial_bus[]; 
extern struct acpi_rsconvert_info acpi_rs_convert_spi_serial_bus[];

extern struct acpi_rsconvert_info acpi_rs_convert_uart_serial_bus[];

extern struct acpi_rsconvert_info acpi_rs_convert_pin_function[];

extern struct acpi_rsconvert_info acpi_rs_convert_pin_config[];



/* These resources require separate get/set tables */
@@ -380,6 +381,7 @@ extern struct acpi_rsdump_info acpi_rs_dump_i2c_serial_bus[]; 
extern struct acpi_rsdump_info acpi_rs_dump_spi_serial_bus[];

extern struct acpi_rsdump_info acpi_rs_dump_uart_serial_bus[];

extern struct acpi_rsdump_info acpi_rs_dump_general_flags[];

extern struct acpi_rsdump_info acpi_rs_dump_pin_config[];

#endif



#endif				/* __ACRESRC_H__ */

drivers/acpi/acpica/acutils.h

+1 −0
Original line number Diff line number Diff line
@@ -85,6 +85,7 @@ extern const char *acpi_gbl_bpb_decode[]; 
extern const char *acpi_gbl_sb_decode[];

extern const char *acpi_gbl_fc_decode[];

extern const char *acpi_gbl_pt_decode[];

extern const char *acpi_gbl_ptyp_decode[];

#endif



/*

drivers/acpi/acpica/amlresrc.h

+23 −0
Original line number Diff line number Diff line
@@ -85,6 +85,8 @@ 
#define ACPI_RESTAG_PHASE                       "_PHA"

#define ACPI_RESTAG_PIN                         "_PIN"

#define ACPI_RESTAG_PINCONFIG                   "_PPI"

#define ACPI_RESTAG_PINCONFIG_TYPE              "_TYP"

#define ACPI_RESTAG_PINCONFIG_VALUE             "_VAL"

#define ACPI_RESTAG_POLARITY                    "_POL"

#define ACPI_RESTAG_REGISTERBITOFFSET           "_RBO"

#define ACPI_RESTAG_REGISTERBITWIDTH            "_RBW"
@@ -425,6 +427,26 @@ struct aml_resource_pin_function { 


#define AML_RESOURCE_PIN_FUNCTION_REVISION      1	/* ACPI 6.2 */



struct aml_resource_pin_config {

	AML_RESOURCE_LARGE_HEADER_COMMON u8 revision_id;

	u16 flags;

	u8 pin_config_type;

	u32 pin_config_value;

	u16 pin_table_offset;

	u8 res_source_index;

	u16 res_source_offset;

	u16 vendor_offset;

	u16 vendor_length;

	/*

	 * Optional fields follow immediately:

	 * 1) PIN list (Words)

	 * 2) Resource Source String

	 * 3) Vendor Data bytes

	 */

};



#define AML_RESOURCE_PIN_CONFIG_REVISION      1	/* ACPI 6.2 */



/* restore default alignment */



#pragma pack()
@@ -468,6 +490,7 @@ union aml_resource { 
	struct aml_resource_uart_serialbus uart_serial_bus;

	struct aml_resource_common_serialbus common_serial_bus;

	struct aml_resource_pin_function pin_function;

	struct aml_resource_pin_config pin_config;



	/* Utility overlays */

drivers/acpi/acpica/rscalc.c

+31 −0
Original line number Diff line number Diff line
@@ -375,6 +375,20 @@ acpi_rs_get_aml_length(struct acpi_resource *resource, 


			break;



		case ACPI_RESOURCE_TYPE_PIN_CONFIG:



			total_size = (acpi_rs_length)(total_size +

						      (resource->data.

						       pin_config.

						       pin_table_length * 2) +

						      resource->data.pin_config.

						      resource_source.

						      string_length +

						      resource->data.pin_config.

						      vendor_length);



			break;



		default:



			break;
@@ -581,6 +595,23 @@ acpi_rs_get_list_length(u8 *aml_buffer, 
			    minimum_aml_resource_length;

			break;



		case ACPI_RESOURCE_NAME_PIN_CONFIG:



			/* Vendor data is optional */



			if (aml_resource->pin_config.vendor_length) {

				extra_struct_bytes +=

				    aml_resource->pin_config.vendor_offset -

				    aml_resource->pin_config.pin_table_offset +

				    aml_resource->pin_config.vendor_length;

			} else {

				extra_struct_bytes +=

				    aml_resource->large_header.resource_length +

				    sizeof(struct aml_resource_large_header) -

				    aml_resource->pin_config.pin_table_offset;

			}

			break;



		default:



			break;

CRA Git | Maintained and supported by SUSTech CRA and CCSE