+35
−8
Loading
Gitlab 现已全面支持 git over ssh 与 git over https。通过 HTTPS 访问请配置带有 read_repository / write_repository 权限的 Personal access token。通过 SSH 端口访问请使用 22 端口或 13389 端口。如果使用CAS注册了账户但不知道密码,可以自行至设置中更改;如有其他问题,请发邮件至 service@cra.moe 寻求协助。
Two initiator ports were cable swapped and after swap both went down. The driver internally swaps the nlp nodes based on matching node wwn's but not the same nport id as before. After detecting a change in the nodes RPI, the driver sends an UNREG_RPI command and clears the NLP_RPI_REGISTERED flag, then swaps the node information with the other node. But the other node's NLP_RPI_REGISTERED flag is also cleared, but it is done so without an UNREG_RPI being sent, which causes the later REG_RPI for that other node to fail as the hardware believes its still registered. Additionally, if the node swap occurred while the two nodes had PLOGI's in flight, the fc4_types weren't properly getting swapped such that when the PLOGIs commpleted and PRLI's were then sent, the PRLI's acted on bad protocol types so the PRLI was for the wrong protocol. NVME devices saw SCSI FCP PRLIs and vice versa. Clean up the node swap so that the NLP_RPI_REGISTERED flag is handled properly. Fix the handling of the fc4_types when the nodes are swapped as well Signed-off-by:Dick Kennedy <dick.kennedy@broadcom.com> Signed-off-by:
James Smart <jsmart2021@gmail.com> Signed-off-by:
Martin K. Petersen <martin.petersen@oracle.com>
CRA Git | Maintained and supported by SUSTech CRA and CCSE