+199
−13
+15
−0
Loading
Gitlab 现已全面支持 git over ssh 与 git over https。通过 HTTPS 访问请配置带有 read_repository / write_repository 权限的 Personal access token。通过 SSH 端口访问请使用 22 端口或 13389 端口。如果使用CAS注册了账户但不知道密码,可以自行至设置中更改;如有其他问题,请发邮件至 service@cra.moe 寻求协助。
This patch adds the analog loopback/bypass support for twl4030 codec. Details for the implementation: It seams that the analog loopback needs the DAC powered on on the channel, where the loopback is selected. The switch for the DACs has been moved from the DAPM_DAC to the "Analog XX Playback Mixer". In this way the DAC will be powered while the audio playback is used or/and the loopback is enabled for the channel. The twl4030 codec powering has been reworked. Now the codec will be powered as long as it does not receives the SND_SOC_BIAS_OFF event. The exceptions are when the given change in the registers needs the codec power down/up cycle in order to take effect. Otherwise the codec is on. When the codec enters to STANDBY state and none of the loopback paths are enabled, than the amplifiers, which are no in the DAPM path are forced to turn off and the PLL is disabled. When playback/capture starts the disabled gains are restored and the PLL is enabled. When one of the loopback enabled in STANDBY mode, the disabled gains are restored and the PLL is enabled also. In short: the codec always goes to the lowest power state based on the bias_level and the bypass_state. Signed-off-by:Peter Ujfalusi <peter.ujfalusi@nokia.com> Signed-off-by:
Mark Brown <broonie@opensource.wolfsonmicro.com>
CRA Git | Maintained and supported by SUSTech CRA and CCSE