Merge series "opp: Unconditionally call dev_pm_opp_of_remove_table()" from...

  - 'css_for_each_descendant_pre'

  - 'device_for_each_child_node'

  - 'dma_fence_chain_for_each'

  - 'do_for_each_ftrace_op'

  - 'drm_atomic_crtc_for_each_plane'

  - 'drm_atomic_crtc_state_for_each_plane'

  - 'drm_atomic_crtc_state_for_each_plane_state'

  - 'for_each_active_dev_scope'

  - 'for_each_active_drhd_unit'

  - 'for_each_active_iommu'

  - 'for_each_aggr_pgid'

  - 'for_each_available_child_of_node'

  - 'for_each_bio'

  - 'for_each_board_func_rsrc'

  - 'for_each_node_state'

  - 'for_each_node_with_cpus'

  - 'for_each_node_with_property'

  - 'for_each_nonreserved_multicast_dest_pgid'

  - 'for_each_of_allnodes'

  - 'for_each_of_allnodes_from'

  - 'for_each_of_cpu_node'

  - 'for_each_pci_dev'

  - 'for_each_pci_msi_entry'

  - 'for_each_pcm_streams'

  - 'for_each_physmem_range'

  - 'for_each_populated_zone'

  - 'for_each_possible_cpu'

  - 'for_each_present_cpu'

  - 'for_each_process_thread'

  - 'for_each_property_of_node'

  - 'for_each_registered_fb'

  - 'for_each_requested_gpio'

  - 'for_each_requested_gpio_in_range'

  - 'for_each_reserved_mem_region'

  - 'for_each_rtd_codec_dais'

  - 'for_each_rtd_codec_dais_rollback'

  - 'for_each_sg'

  - 'for_each_sg_dma_page'

  - 'for_each_sg_page'

  - 'for_each_sgtable_dma_page'

  - 'for_each_sgtable_dma_sg'

  - 'for_each_sgtable_page'

  - 'for_each_sgtable_sg'

  - 'for_each_sibling_event'

  - 'for_each_subelement'

  - 'for_each_subelement_extid'

  - 'for_each_subelement_id'

  - '__for_each_thread'

  - 'for_each_thread'

  - 'for_each_unicast_dest_pgid'

  - 'for_each_wakeup_source'

  - 'for_each_zone'

  - 'for_each_zone_zonelist'

  - 'v4l2_m2m_for_each_src_buf'

  - 'v4l2_m2m_for_each_src_buf_safe'

  - 'virtio_device_for_each_vq'

  - 'while_for_each_ftrace_op'

  - 'xa_for_each'

  - 'xa_for_each_marked'

  - 'xa_for_each_range'

		is invoked by both RCU-sched readers and updaters.

	srcu_dereference_check(p, c):

		Use explicit check expression "c" along with

		srcu_read_lock_held()().  This is useful in code that

		srcu_read_lock_held().  This is useful in code that

		is invoked by both SRCU readers and updaters.

	rcu_dereference_raw(p):

		Don't check.  (Use sparingly, if at all.)

  98 block	User-mode virtual block device

		  0 = /dev/ubda		First user-mode block device

		 16 = /dev/udbb		Second user-mode block device

		 16 = /dev/ubdb		Second user-mode block device

		    ...

		Partitions are handled in the same way as for IDE

DYTC Lapmode sensor

------------------

-------------------

sysfs: dytc_lapmode

internal P-state selection logic is expected to focus entirely on performance.

This will override the EPP/EPB setting coming from the ``sysfs`` interface

(see `Energy vs Performance Hints`_ below).

(see `Energy vs Performance Hints`_ below).  Moreover, any attempts to change

the EPP/EPB to a value different from 0 ("performance") via ``sysfs`` in this

configuration will be rejected.

Also, in this configuration the range of P-states available to the processor's

internal P-state selection logic is always restricted to the upper boundary

Energy-Performance Bias (EPB) knob. It is also possible to write a positive

integer value between 0 to 255, if the EPP feature is present. If the EPP

feature is not present, writing integer value to this attribute is not

supported. In this case, user can use

supported. In this case, user can use the

"/sys/devices/system/cpu/cpu*/power/energy_perf_bias" interface.

[Note that tasks may by migrated from one CPU to another by the scheduler's