+147
−0
Loading
Gitlab 现已全面支持 git over ssh 与 git over https。通过 HTTPS 访问请配置带有 read_repository / write_repository 权限的 Personal access token。通过 SSH 端口访问请使用 22 端口或 13389 端口。如果使用CAS注册了账户但不知道密码,可以自行至设置中更改;如有其他问题,请发邮件至 service@cra.moe 寻求协助。
The r8a7790/lager and r8a7791/koelsch development boards have da9063 and da9210 regulators. Both regulators have their interrupt request lines tied to the same interrupt pin (IRQ2) on the SoC. After cold boot or da9063-induced restart, both the da9063 and da9210 seem to assert their interrupt request lines. Hence as soon as one driver requests this irq, it gets stuck in an interrupt storm, as it only manages to deassert its own interrupt request line, and the other driver hasn't installed an interrupt handler yet. To handle this, install a quirk that masks the interrupts in both the da9063 and da9210. This quirk has to run after the i2c master driver has been initialized, but before the i2c slave drivers are initialized. As it depends on i2c, select I2C if one of the affected platforms is enabled in the kernel config. On koelsch, the following happens: - Cold boot or reboot using the da9063 restart handler: IRQ2 is asserted, installing da9063/da9210 regulator quirk ... i2c i2c-6: regulator_quirk_notify: 1, IRQC_MONITOR = 0x3fb i2c 6-0058: regulator_quirk_notify: 1, IRQC_MONITOR = 0x3fb i2c 6-0058: Detected da9063 i2c 6-0058: Masking da9063 interrupt sources i2c 6-0068: regulator_quirk_notify: 1, IRQC_MONITOR = 0x3fb i2c 6-0068: Detected da9210 i2c 6-0068: Masking da9210 interrupt sources i2c 6-0068: IRQ2 is not asserted, removing quirk - Warm boot (reset button): rcar_gen2_regulator_quirk: IRQ2 is not asserted, not installing quirk Signed-off-by:Geert Uytterhoeven <geert+renesas@glider.be> Tested-by:
Wolfram Sang <wsa+renesas@sang-engineering.com> Reviewed-by:
Mark Brown <broonie@kernel.org> Signed-off-by:
Simon Horman <horms+renesas@verge.net.au>
CRA Git | Maintained and supported by SUSTech CRA and CCSE