net: sfp: use a definition for the fault recovery attempts

#define T_RESET_US		10

#define T_FAULT_RECOVER		msecs_to_jiffies(1000)

/* N_FAULT_INIT is the number of recovery attempts at module initialisation

 * time. If the TX_FAULT signal is not deasserted after this number of

 * attempts at clearing it, we decide that the module is faulty.

 * N_FAULT is the same but after the module has initialised.

 */

#define N_FAULT_INIT		5

#define N_FAULT			5

/* SFP module presence detection is poor: the three MOD DEF signals are

 * the same length on the PCB, which means it's possible for MOD DEF 0 to

 * connect before the I2C bus on MOD DEF 1/2.

		sfp_module_tx_enable(sfp);

		/* Initialise the fault clearance retries */

		sfp->sm_retries = 5;

		sfp->sm_retries = N_FAULT_INIT;

		/* We need to check the TX_FAULT state, which is not defined

		 * while TX_DISABLE is asserted. The earliest we want to do

			 * or t_start_up, so assume there is a fault.

			 */

			sfp_sm_fault(sfp, SFP_S_INIT_TX_FAULT,

				     sfp->sm_retries == 5);

				     sfp->sm_retries == N_FAULT_INIT);

		} else if (event == SFP_E_TIMEOUT || event == SFP_E_TX_CLEAR) {

	init_done:	/* TX_FAULT deasserted or we timed out with TX_FAULT

			 * clear.  Probe for the PHY and check the LOS state.

			sfp_sm_link_check_los(sfp);

			/* Reset the fault retry count */

			sfp->sm_retries = 5;

			sfp->sm_retries = N_FAULT;

		}

		break;