+3
−6
+30
−11
Loading
Gitlab 现已全面支持 git over ssh 与 git over https。通过 HTTPS 访问请配置带有 read_repository / write_repository 权限的 Personal access token。通过 SSH 端口访问请使用 22 端口或 13389 端口。如果使用CAS注册了账户但不知道密码,可以自行至设置中更改;如有其他问题,请发邮件至 service@cra.moe 寻求协助。
This patch does what the rfc6951#section-5.3 says for ipv4:
"Within the UDP header, the source port MUST be the local UDP
encapsulation port number of the SCTP stack, and the destination port
MUST be the remote UDP encapsulation port number maintained for the
association and the destination address to which the packet is sent
(see Section 5.1).
Because the SCTP packet is the UDP payload, the length of the UDP
packet MUST be the length of the SCTP packet plus the size of the UDP
header.
The SCTP checksum MUST be computed for IPv4 and IPv6, and the UDP
checksum SHOULD be computed for IPv4 and IPv6."
Some places need to be adjusted in sctp_packet_transmit():
1. For non-gso packets, when transport's encap_port is set, sctp
checksum has to be done in sctp_packet_pack(), as the outer
udp will use ip_summed = CHECKSUM_PARTIAL to do the offload
setting for checksum.
2. Delay calling dst_clone() and skb_dst_set() for non-udp packets
until sctp_v4_xmit(), as for udp packets, skb_dst_set() is not
needed before calling udp_tunnel_xmit_skb().
then in sctp_v4_xmit():
1. Go to udp_tunnel_xmit_skb() only when transport->encap_port and
net->sctp.udp_port both are set, as these are one for dst port
and another for src port.
2. For gso packet, SKB_GSO_UDP_TUNNEL_CSUM is set for gso_type, and
with this udp checksum can be done in __skb_udp_tunnel_segment()
for each segments after the sctp gso.
3. inner_mac_header and inner_transport_header are set, as these
will be needed in __skb_udp_tunnel_segment() to find the right
headers.
4. df and ttl are calculated, as these are the required params by
udp_tunnel_xmit_skb().
5. nocheck param has to be false, as "the UDP checksum SHOULD be
computed for IPv4 and IPv6", says in rfc6951#section-5.3.
v1->v2:
- Use sp->udp_port instead in sctp_v4_xmit(), which is more safe.
Signed-off-by:
Xin Long <lucien.xin@gmail.com>
Acked-by:
Marcelo Ricardo Leitner <marcelo.leitner@gmail.com>
Signed-off-by:
Jakub Kicinski <kuba@kernel.org>
CRA Git | Maintained and supported by SUSTech CRA and CCSE