+27
−10
Loading
Gitlab 现已全面支持 git over ssh 与 git over https。通过 HTTPS 访问请配置带有 read_repository / write_repository 权限的 Personal access token。通过 SSH 端口访问请使用 22 端口或 13389 端口。如果使用CAS注册了账户但不知道密码,可以自行至设置中更改;如有其他问题,请发邮件至 service@cra.moe 寻求协助。
This patch adds transport ports information for route lookup so that IPsec can select Geneve tunnel traffic to do encryption. This is needed for OVS/OVN IPsec with encrypted Geneve tunnels. This can be tested by configuring a host-host VPN using an IKE daemon and specifying port numbers. For example, for an Openswan-type configuration, the following parameters should be configured on both hosts and IPsec set up as-per normal: $ cat /etc/ipsec.conf conn in ... left=$IP1 right=$IP2 ... leftprotoport=udp/6081 rightprotoport=udp ... conn out ... left=$IP1 right=$IP2 ... leftprotoport=udp rightprotoport=udp/6081 ... The tunnel can then be setup using "ip" on both hosts (but changing the relevant IP addresses): $ ip link add tun type geneve id 1000 remote $IP2 $ ip addr add 192.168.0.1/24 dev tun $ ip link set tun up This can then be tested by pinging from $IP1: $ ping 192.168.0.2 Without this patch the traffic is unencrypted on the wire. Fixes: 2d07dc79 ("geneve: add initial netdev driver for GENEVE tunnels") Signed-off-by:Qiuyu Xiao <qiuyu.xiao.qyx@gmail.com> Signed-off-by:
Mark Gray <mark.d.gray@redhat.com> Reviewed-by:
Greg Rose <gvrose8192@gmail.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
CRA Git | Maintained and supported by SUSTech CRA and CCSE