dt-bindings: phy: Add support for the USB3 PHY on Amlogic Meson GXL SoCs (324e46ce) · Commits · 戴 / test

Amlogic Meson GXL SoCs use a dwc3 controller with two (GXM - a variant for GXL, has three) USB2 ports. The first USB2 port supports host and peripheral (also called "device") mode. While the dwc3 controller has no USB3 port enabled we still need the USB3 PHY to be initialized. Otherwise high-speed USB transfers (for example with a USB flash drive) may time out (most often seen on boards with mainline u-boot, where the bootloader does not initialize the USB3 PHY registers). Signed-off-by:

Martin Blumenstingl <martin.blumenstingl@googlemail.com> Reviewed-by:

Rob Herring <robh@kernel.org> Tested-by:

Yixun Lan <yixun.lan@amlogic.com> Tested-by:

Neil Armstrong <narmstrong@baylibre.com> Signed-off-by:

Kishon Vijay Abraham I <kishon@ti.com>

Documentation/devicetree/bindings/phy/meson-gxl-usb3-phy.txt

0 → 100644

+31 −0

Original line number	Diff line number	Diff line
		* Amlogic Meson GXL and GXM USB3 PHY and OTG detection binding

		Required properties:
		- compatible: Should be "amlogic,meson-gxl-usb3-phy"
		- #phys-cells: must be 0 (see phy-bindings.txt in this directory)
		- reg: The base address and length of the registers
		- interrupts: the interrupt specifier for the OTG detection
		- clocks: phandles to the clocks for
		- the USB3 PHY
		- and peripheral mode/OTG detection
		- clock-names: must contain "phy" and "peripheral"
		- resets: phandle to the reset lines for:
		- the USB3 PHY and
		- peripheral mode/OTG detection
		- reset-names: must contain "phy" and "peripheral"

		Optional properties:
		- phy-supply: see phy-bindings.txt in this directory


		Example:
		usb3_phy0: phy@78080 {
		compatible = "amlogic,meson-gxl-usb3-phy";
		#phy-cells = <0>;
		reg = <0x0 0x78080 0x0 0x20>;
		interrupts = <GIC_SPI 16 IRQ_TYPE_LEVEL_HIGH>;
		clocks = <&clkc CLKID_USB_OTG>, <&clkc_AO CLKID_AO_CEC_32K>;
		clock-names = "phy", "peripheral";
		resets = <&reset RESET_USB_OTG>, <&reset RESET_USB_OTG>;
		reset-names = "phy", "peripheral";
		};

Admin message