ARM: shmobile: Koelsch: pass Ether PHY IRQ (29d9f010) · Commits · 戴 / test

Pass Ether's PHY IRQ (which is IRQC's IRQ0) to the 'sh_eth' driver. Set the IRQ trigger type to be low-level as per the Micrel PHY driver's setup. Signed-off-by:

Sergei Shtylyov <sergei.shtylyov@cogentembedded.com> Acked-by:

Magnus Damm <magnus.damm@gmail.com> Signed-off-by:

Simon Horman <horms+renesas@verge.net.au>

arch/arm/mach-shmobile/board-koelsch.c

+4 −0

Original line number	Diff line number	Diff line
		@@ -23,6 +23,7 @@
		#include <linux/gpio.h>
		#include <linux/gpio_keys.h>
		#include <linux/input.h>
		#include <linux/irq.h>
		#include <linux/kernel.h>
		#include <linux/leds.h>
		#include <linux/phy.h>
		@@ -92,6 +93,7 @@ static void __init koelsch_add_du_device(void)
		/* Ether */
		static const struct sh_eth_plat_data ether_pdata __initconst = {
		.phy = 0x1,
		.phy_irq = irq_pin(0),
		.edmac_endian = EDMAC_LITTLE_ENDIAN,
		.phy_interface = PHY_INTERFACE_MODE_RMII,
		.ether_link_active_low = 1,
		@@ -232,6 +234,8 @@ static void __init koelsch_init(void)
		{
		koelsch_add_standard_devices();

		irq_set_irq_type(irq_pin(0), IRQ_TYPE_LEVEL_LOW);

		if (IS_ENABLED(CONFIG_PHYLIB))
		phy_register_fixup_for_id("r8a7791-ether-ff:01",
		koelsch_ksz8041_fixup);

Admin message