Commit 1f44a2a5 authored by Seungwon Jeon's avatar Seungwon Jeon Committed by Chris Ball
Browse files

mmc: dw_mmc: set the supported max/min frequency 



Both f_max and f_min will be informed for core layer to request
valid clock rate. But current setting from 'host->bus_hz' may
not represent the max/min frequency properly. Even if host can
actually support high speed than bus_hz, core layer will not
request clock rate over bus_hz. Basically, f_max/f_min can be set
with the values according to spec. And then host will make its best
effort to meet the rate.

Signed-off-by: default avatarSeungwon Jeon <tgih.jun@samsung.com>
Tested-by: default avatarAlim Akhtar <alim.akhtar@samsung.com>
Signed-off-by: default avatarChris Ball <cjb@laptop.org>
parent 10b49841

Documentation/devicetree/bindings/mmc/synopsis-dw-mshc.txt

+4 −0
Original line number Diff line number Diff line
@@ -52,6 +52,9 @@ Optional properties: 
  is specified and the ciu clock is specified then we'll try to set the ciu

  clock to this at probe time.



* clock-freq-min-max: Minimum and Maximum clock frequency for card output

  clock(cclk_out). If it's not specified, max is 200MHZ and min is 400KHz by default.



* num-slots: specifies the number of slots supported by the controller.

  The number of physical slots actually used could be equal or less than the

  value specified by num-slots. If this property is not specified, the value
@@ -97,6 +100,7 @@ board specific portions as listed below. 


	dwmmc0@12200000 {

		clock-frequency = <400000000>;

		clock-freq-min-max = <400000 200000000>;

		num-slots = <1>;

		supports-highspeed;

		caps2-mmc-hs200-1_8v;

drivers/mmc/host/dw_mmc.c

+12 −2
Original line number Diff line number Diff line
@@ -50,6 +50,9 @@ 
#define DW_MCI_RECV_STATUS	2

#define DW_MCI_DMA_THRESHOLD	16



#define DW_MCI_FREQ_MAX	200000000	/* unit: HZ */

#define DW_MCI_FREQ_MIN	400000		/* unit: HZ */



#ifdef CONFIG_MMC_DW_IDMAC

#define IDMAC_INT_CLR		(SDMMC_IDMAC_INT_AI | SDMMC_IDMAC_INT_NI | \

				 SDMMC_IDMAC_INT_CES | SDMMC_IDMAC_INT_DU | \
@@ -1936,6 +1939,7 @@ static int dw_mci_init_slot(struct dw_mci *host, unsigned int id) 
	struct dw_mci_slot *slot;

	const struct dw_mci_drv_data *drv_data = host->drv_data;

	int ctrl_id, ret;

	u32 freq[2];

	u8 bus_width;



	mmc = mmc_alloc_host(sizeof(struct dw_mci_slot), host->dev);
@@ -1951,8 +1955,14 @@ static int dw_mci_init_slot(struct dw_mci *host, unsigned int id) 
	slot->quirks = dw_mci_of_get_slot_quirks(host->dev, slot->id);



	mmc->ops = &dw_mci_ops;

	mmc->f_min = DIV_ROUND_UP(host->bus_hz, 510);

	mmc->f_max = host->bus_hz;

	if (of_property_read_u32_array(host->dev->of_node,

				       "clock-freq-min-max", freq, 2)) {

		mmc->f_min = DW_MCI_FREQ_MIN;

		mmc->f_max = DW_MCI_FREQ_MAX;

	} else {

		mmc->f_min = freq[0];

		mmc->f_max = freq[1];

	}



	if (host->pdata->get_ocr)

		mmc->ocr_avail = host->pdata->get_ocr(id);

CRA Git | Maintained and supported by SUSTech CRA and CCSE