iio: light: rpr0521 poweroff for probe fails (12d74949) · Commits · 戴 / test

Set sensor measurement off after probe fail in pm_runtime_set_active() or iio_device_register(). Without this change sensor measurement stays on even though probe fails on these calls. This is maybe rare case, but causes constant power drain without any benefits when it happens. Power drain is 20-500uA, typically 180uA. Signed-off-by:

Mikko Koivunen <mikko.koivunen@fi.rohmeurope.com> Acked-by:

Daniel Baluta <daniel.baluta@nxp.com> Signed-off-by:

Jonathan Cameron <jic23@kernel.org>

drivers/iio/light/rpr0521.c

+15 −2

Original line number	Diff line number	Diff line
		@@ -516,13 +516,26 @@ static int rpr0521_probe(struct i2c_client *client,

		ret = pm_runtime_set_active(&client->dev);
		if (ret < 0)
		return ret;
		goto err_poweroff;

		pm_runtime_enable(&client->dev);
		pm_runtime_set_autosuspend_delay(&client->dev, RPR0521_SLEEP_DELAY_MS);
		pm_runtime_use_autosuspend(&client->dev);

		return iio_device_register(indio_dev);
		ret = iio_device_register(indio_dev);
		if (ret)
		goto err_pm_disable;

		return 0;

		err_pm_disable:
		pm_runtime_disable(&client->dev);
		pm_runtime_set_suspended(&client->dev);
		pm_runtime_put_noidle(&client->dev);
		err_poweroff:
		rpr0521_poweroff(data);

		return ret;
		}

		static int rpr0521_remove(struct i2c_client *client)

Admin message